Stop Shower Leaks and Other Basic Bathroom Leak Repairs

Usually, the easiest way to tell if you have leaking problems in your bathroom is if you find stains on the ceiling below. Bathroom leaks are very common, as water will always find its way out through small gaps. However, it is important to stop shower leaks and all sorts of bathroom leaks before the problems get out of hand. Here are some basic plumbing tips for your bathroom.

Stop shower leaks before they happen

One of the first things any commercial waterproofing Melbourne company would tell you to stop leaks in your bathroom (or anywhere else in your house for that matter!) is to prevent leaks from happening in the first place. This involves checking your sealant occasionally, and to watch out for signs of mildew or mould build up in your sealant. This is a tell-tale sign that water is being collected and absorbed by your sealant rather letting them run down and drain away. Also, water could be leaking through minute crevices in your sealant, so make sure you take note of these signs.

commercial waterproofing melbourne

commercial waterproofing melbourne

 

As soon as you find little cervices or cracks in your sealant, you should remedy it right away before it makes further damage in your bathroom. Stains are sure-fire signs of leaks, but water leaks can also cause damages to the floor boards and joints, which could later compromise the structural integrity of your bathroom. Mildew and mould also has a tendency to leave a damp smell. If you want to sell your home in the future, it pays to solve these leak problems before they worsen, or to ensure that it never happens in the first place.

Find the source of bathroom leaks

The shower hob is often the wettest place inside your bathroom, because of which, it is also the most damp and be a prime place where leaks begin. However, leaks can come from anywhere, and to solve this problem, you have to find the source. A brown water stain on your ceiling is a good place to begin the trace. But before you call your plumber, spend some time to know exactly where the leak is at. Don’t just assume it’s a pipe leak problem. It can be a simple problem like a gap in your sealant.

An easy way to do this is take a tape measure or ruler and measure the stain on the ceiling from a wall or corner of the room. Take note of your measurement, then go to your bathroom and make the same measurement to match the leak source to the stain beyond.

Replace your sealant

Unless you’re great in DIY, don’t try to remove the entire sealant around the shower hob. The best thing you can do is deal with the already damaged areas. Sealant application can be quite tricky. So instead of doing the sealing on your own, you can clean the area properly, without using much water. Then, use a sharp Stanley knife to remove or loose sealants that are damaged.

Make sure the problematic area is clean and dry

Your wife’s beauty items like sharp tweezers and hair dryer are powerful tools to help keep bathroom areas dry before you or an expert conduct the neccessary repairs. Remove lose debris using the tweezers. Soak up the remaining water using a piece of kitchen roll or cloth rag, then use the hairdryer to blow the cracks dry quickly.

If you’re having serious leaking problems with your shower and bathroom, then the best way to stop shower leaks or other leak problems is call your local plumber. For bigger projects that involves tiling, renovation and building and waterproofing, check out Waterstop Streamline. It is one of the most sought-after home improvement companies in Queensland today. Their website at http://www.waterstopstreamline.com.au/.

Leave a Reply

Your email address will not be published. Required fields are marked *